Your guide to key fastener terms & technology
The highest value of prevailing torque produced the first time the self-locking fastener is being installed. This is taken during the first five revolutions after engaging the locking element and before seating.
Seating Torque [Loading Torque, Tightening Torque]
A value of torque typically measured in “inch pounds” applied to a fastener to induce a compressive load under the head bearing surface that results in creating an axial load (pre-load).
The amount of torque required to put into reverse rotation a fastener that is in the seated, clamped or tightened position. The torque is due to clamp load and not related to prevailing torque.
Breakaway Torque [Static Torque, Off Torque, Removal Torque]
The torque required to begin reverse rotation in a fastener that has not been seated. This will change with reuse, they are referred to as the “1st Off, 5th Off” torque. This torque is due to the locking element only and is considered a critical performance characteristic of a locking component.
Prevailing “Off” Torque
The torque readings taken as the part is backed off during the first 360° of rotation. This is after clamp load has been reduced to zero.
Prevailing Torque [Running Torque]
An average measure of frictional resistance produced during rotation in either the installation or removal cycle. It is independent of clamp load. This is unique to self-locking fasteners and components.
INSTALLATION TORQUE RECOMMENDATIONS
1/3 of initial installation value i.e. MIL spec.
2/3 of initial installation value i.e. MIL spec., plus requirement of removals and clamp load. Example: If the maximum initial installation torque is 100 in. lbs, it would be two-thirds @ 66 in. lbs with a potential variance ranging between 60-75 in. lbs.
3/3 of initial installation value i.e. MIL spec., plus requirement of removals and clamp load.
2 to 5 in. lbs initial installation only. Removal torque for reference only. Parts to be assembled/dissembled by hand/fingers.